A 5-inch freestyle quad needs a 225 mm carbon frame, 2207 motors near 1750KV for 6S, and a 30.5 mm stack. Match every part to the same cell count before you order. This guide lists the frame, motors, stack, camera, and props that fit a standard 5-inch build, with live links to each part.
What frame size fits a 5-inch freestyle quad?
A 5-inch frame measures about 225 mm across the motor diagonal. The APEX 5 frame uses 5.5 mm carbon arms, which survive hard freestyle crashes.
Check the stack mounting pattern before you buy. Most 5-inch frames take a 30.5 mm by 30.5 mm flight controller stack.
Which motors suit a 5-inch 6S freestyle quad?
2207 size motors near 1750KV are the standard pick for 6S freestyle. KV means revolutions per minute per volt with no load, so 1750KV on 22.2 V spins near 38,850 RPM unloaded.
An RS2205 2300KV motor suits a 4S build instead. Never run a 2300KV motor on 6S, because the higher voltage pushes RPM past the design range.
How do you pick a flight controller stack?
A stack pairs a flight controller with a 4-in-1 ESC on one mounting pattern. A 50 A ESC covers 2207 motors on 6S with room for current spikes.
Betaflight is the firmware most freestyle pilots run on F4 and F7 boards. The SpeedyBee F7 V3 stack pairs an F7 board with a 50 A BL32 ESC.
Which props fit a 5-inch quad?
Use 5.1 inch props with a 5 mm center bore for 2207 motors. Three-blade props give more grip in turns, while two-blade props give more top speed.
A 3.5 inch tri-blade prop fits a small 3.5 inch frame, not a 5-inch frame. Always match prop diameter to the frame size first.
What camera and video transmitter do you need?
A micro FPV camera measures 19 mm by 19 mm and outputs 1200TVL analog video. The RunCam Phoenix 2 SP V5 adds night vision for low-light flying.
A 5.8 GHz video transmitter at 800 mW gives solid range for freestyle. The SpeedyBee TX800 runs at 800 mW on 48 channels with SmartAudio control.
Should you build 4S or 6S?
A 4S pack reads 14.8 V nominal, and a 6S pack reads 22.2 V nominal. 6S gives the same power at lower current, so wires and connectors run cooler.
Pick 6S for a new freestyle build with 1750KV motors. Pick 4S only if you already own 4S packs and 2300KV motors.
Quick comparison
| Setup | Nominal voltage | Motor KV | Prop size | ESC rating |
|---|---|---|---|---|
| 4S freestyle | 14.8 V | 2300KV | 5.1 inch | 45 A |
| 6S freestyle | 22.2 V | 1750KV | 5.1 inch | 50 A |
Frequently asked questions
Can I reuse 4S motors on a 6S build?
No. A 2300KV motor on 22.2 V spins far past its design range and draws excess current. Buy 1750KV motors for 6S.
What does 30.5 mm mean on a flight controller stack?
It is the distance between mounting holes, 30.5 mm by 30.5 mm. Your frame must have the same mounting pattern.
How much current does a 5-inch quad draw?
A freestyle quad can pull over 100 A in a full-throttle punch on 6S. Size the ESC and battery leads for peaks, not for cruise current.
Do I need a capacitor on the ESC?
Yes, in most builds. A low-ESR capacitor across the battery pads cuts voltage spikes that can damage the ESC and the flight controller.
Parts used
APEX 5 5-Inch Carbon Fiber FPV Frame Kit, 225mm, 5.5mm Arms, $52.99. APEX 5 5-inch carbon fiber FPV freestyle frame kit, 225mm wheelbase, 5.5mm arms, about 138g. Frame kit or 3D printed parts version. Takes 5-inch props, 2205-2306 motors, 30-50A ESCs. Ships from NY, USA.
XING-E Pro 2207 Brushless Motor, 1800/2450/2750KV, 2-6S, for 5 Inch Props, $59.99. iFlight XING-E Pro 2207 brushless motor in 1800/2450/2750KV, 2-6S compatible with 5 inch props. Unibell design for smooth, durable FPV racing power. Ships from NY, USA.
RS2205 2300KV Brushless Motor, CW/CCW, for 5 Inch FPV Racing, $5.99. RS2205 2300KV brushless motor for 5 inch FPV racing quads. Race-spec with N52 magnets and Japanese bearings, CW/CCW options. Ships from NY, USA.
SpeedyBee F7 V3 50A Stack with BL32 4-in-1 ESC for FPV Racing, $145.99. SpeedyBee F7 V3 stack with BL32 50A 4-in-1 ESC for FPV racing. FC only, ESC only, or full stack. STM32F722, BMI270, Bluetooth config. Ships from NY, USA.
Aocoda F465S V4 Stack with F405 FC and 65A ESC for FPV Racing, $96.29. Aocoda F465S V4 stack with F405 flight controller and 65A ESC, 30x30mm for FPV racing drones. F465S V4 or F475S V4. Ships from NY, USA.
UAngel F722 F7 Flight Controller Stack with 45A/60A 4-in-1 ESC and VTX1000 for FPV Racing, $54.87. UAngel F722 F7 flight controller stack with BLHeli_S 45A/60A 4-in-1 ESC, FC only, ESC only, stack, or stack with VTX1000. STM32F722, ICM42688, Betaflight. Ships from NY, USA.
RunCam Phoenix 2 SP V5 FPV Camera 1200TVL Night Vision 19x19mm Micro, $73.99. RunCam Phoenix 2 SP V5 micro FPV camera, 1200TVL night-vision, 4:3/16:9 and NTSC/PAL switchable, 5-36V, 19x19mm, 7.5g. Cable, screws, and manual included. Ships from NY, USA.
Caddx Ratel 2 V2 FPV Camera 1200TVL 2.1mm Lens 19x19mm Micro, $71.99. Caddx Ratel 2 V2 micro FPV camera, 1200TVL with a 2.1mm lens, 16:9/4:3 and NTSC/PAL switchable, 19x19mm mount. Black or red. Includes OSD board, cable, and bracket. Ships from NY, USA.
SpeedyBee TX800 VTX 800mW 5.8GHz 48CH Video Transmitter for FPV Racing, $57.72. SpeedyBee TX800 analog VTX, 800mW max on 5.8GHz, 48 channels, IRC Tramp, 20x20mm, 5V input. The budget 800mW stack VTX every 5″ build needs. Ships from NY, USA.
GEPRC RAD 1.6W VTX 5.8GHz 40CH IRC Tramp SmartAudio Long Range, $142.99. GEPRC RAD 1.6W VTX, 5.8GHz 40CH, PIT-1600mW, 2-8S in, IRC Tramp + SmartAudio, MMCX, 9.7g. Antenna, pigtail, hardware, and case included. Ships from NY, USA.
T3.5×2.5×3 3525 Flower Tri-Blade 3.5 Inch FPV Props, $14.48. HQProp T3.5×2.5×3 flower-profile tri-blade 3.5 inch FPV propellers. Smooth, efficient cruising props. Ships from NY, USA.
3016 3 Inch 4-Blade Props, 8 Pairs, $31.99. DarwinFPV 3016 3 inch 4-blade propellers, 8 pairs for 3 inch FPV builds. Ships from NY, USA.
FPVRACER Kevlar Battery Straps, 2-Pack, Metal Buckle, $8.57. FPVRACER Kevlar battery straps, 2-pack with metal buckle. Kevlar suture and polyester 300D, hook-and-loop fastening for FPV racing and long-range drones. Five sizes, 10x130mm to 20x260mm. Ships from NY, USA.
180-Piece M3 Black Nylon Standoff Spacer Kit for FPV Drone Frames, Hex, 6-20mm, $9.81. 180-piece M3 black nylon standoff, screw and nut kit for RC FPV drone quadcopter frames. Male-female hex spacers 6 to 20mm plus M3 screws and nuts in a storage box. Ships from NY, USA.
Related buying guides on Quality RC Parts
FPV Flight Controllers and ESCs in the USA
Browse all the guides on the Quality RC Parts Drone Guides hub, or start at the Quality RC Parts store.
Sources
- Betaflight: open source flight controller firmware
- Wikipedia: Brushless DC electric motor (KV definition)
- HobbyWing: ESC and motor product documentation
Quality RC Parts stocks parts in New York, USA and ships in-stock orders in 1-2 business days.
Last updated: 2026-11-10.